Rate this topic:

327 posts in this topic

Pulled the cam out today (One of the lobes is worn out). Also installed new oil pump. Tomorrow I'll install the cam, also going to take the heads checked out and install new seals and springs.

Any good place to take heads and have them checked? I won't go to schacklett

Cody likes this

Share this post


Link to post
Share on other sites

I have a couple buddies that used them and screwed them. I also used them and they screwed me too. They'll never get my business again. I showed them their error the same day I went to pick up my intake and they pretty much said to bad and leave. So **** them

Share this post


Link to post
Share on other sites

Also my intake was supposed to be done in a couple days but it took them weeks to do and they the price of the job **** near doubled. So it took them weeks to do my job and almost doubled in price and it was not done right

Share this post


Link to post
Share on other sites

Heads looks nice, bro!

How the crap can a cam lobe get that worn on just one cylinder?

Have you checked out the shortblock bearings and ring gap, etc?

Better to do it now than put it back together and find out the bottom needs work.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.